How can I join hlorvinilovuyu film

Here's how: place of gluing two pieces of film rubbed with a cloth dampened with alcohol or cologne, and stack them on the table. Edge of one piece of the film should overlap the edge of another so as to form "joint" had a width of 2-3 cm under this seam to enclose the strip of plywood the same width as the seam itself. Top seam impose folded in half sheet of tracing paper, which will prevent the film from sticking to the iron. In several places along the seam it should fix the weight to pieces of film from slipping while you work. For greater strength at the ends of suture impose small strips of film, covering the seam of top and bottom. Iron has to be heated, as for conventional ironing, but it is better first to try its effect on individual pieces of film, to be sure, not too hot. Straightening out the seam by hand, lead iron with sufficient pressure along the seam. Must not be allowed to touch the iron directly to the film itself. In addition, you must make sure that between the bonding surfaces were not wrinkled, folded, and air bubbles.